Difference between revisions of "K-Frame"
(New page: The K-frame was introduced during the development of the unitbody design, which design benefits of incorporating the chassis or frame into the body components. While forward and rear frame...) |
|||
| Line 1: | Line 1: | ||
| − | The K-frame was introduced during the development of the unitbody design, which | + | The K-frame was introduced during the development of the [[unitbody]] design, which increases strength by incorporating the chassis or frame into the body components. While forward and rear framerails protruded from the central cab, certain crossmembers were used to tie the exposed rails together. |
| + | |||
| + | The K-Frame is both an engine cradle with motor mounts and the suspension's lower contol arms. The front spindles go between the lower control arms and upper A-arms, which are mated to the inner fenderwells and forward framerails. The steering is then attached. | ||
Factory K-frames were made from two pieces of stamped and molded heavy-gauge sheetmetal, spot-welded together into the characteristic "K" shape from which it got its name. Thick plates were welded on for the steering box perch and motor mounts. | Factory K-frames were made from two pieces of stamped and molded heavy-gauge sheetmetal, spot-welded together into the characteristic "K" shape from which it got its name. Thick plates were welded on for the steering box perch and motor mounts. | ||
[[Category:Parts]] | [[Category:Parts]] | ||
Revision as of 04:36, 13 May 2012
The K-frame was introduced during the development of the unitbody design, which increases strength by incorporating the chassis or frame into the body components. While forward and rear framerails protruded from the central cab, certain crossmembers were used to tie the exposed rails together.
The K-Frame is both an engine cradle with motor mounts and the suspension's lower contol arms. The front spindles go between the lower control arms and upper A-arms, which are mated to the inner fenderwells and forward framerails. The steering is then attached.
Factory K-frames were made from two pieces of stamped and molded heavy-gauge sheetmetal, spot-welded together into the characteristic "K" shape from which it got its name. Thick plates were welded on for the steering box perch and motor mounts.
